High Accuracy Laser Distance Meter Mini Range Finder Green Light
Range Finde Low Cost
Unpacking inspection
| 1, Mainframe | one unit |
| 2, User manual | one piece |
| 3, AAA battery(2*1.5V) | two pieces |
| 4, holding rope | one piece |
Technical Parameters:
Comment:
* The deviation occurs under unfavorable conditions such as bright
sunlight or when measuring too poorly reflecting or very rough
surfaces, the environment temperature is too high or too low.
* When measuring distance within 10m, measurement accuracy
is±1.5mm; more than 10m, measurement accuracy is calculated as
follows:±1.5mm±0.05*(D-10)(D: Measuring Distance, Unit: m)
| Measuring Range | 0.05m~40m
0.05m~60m
0.05m~80m
0.05m~100m
0.05m~120m
0.05m~150m |
| Measuring Accuracy | ±1.5mm |
| Measuring Unit | m,ft,in |
| Laser type | 620~690nm |
| Laser Class | Ⅱclass,<1mW |
| Single Measurement Time | 0.25s |
| Operating Temperature | 0~+40 ℃ |
| Storage Temperature | -20~+65℃ |
| Batteries | AAA(Alkaline), 2x1.5V |
| Measurements Per Battery Set | >8000 |
| Weight (Without Batteries) | Approximately 82g |
| Dimensions(LxW×H) | 115X50X23mm |
Introduction
Firstly thank you for your choice on our handheld laser distance
meter.
Please carefully read the safety instructions and the user manual
before using this product, otherwise it may result in hazardous
laser radiation and electric shock. The person responsible for the
equipment must ensure that all users understand these directions
and adhere to them.
Safety Instructions
1. This product is a class n laser product. Please DO NOT stare
into beam at any time when operating this product!
2. Please DO NOT looking directly into the beam with optical aids
(e.g. binoculars, telescopes)!
Please DO NOT remove any safety labels on this product!
Caution:
1. Please avoid kids to use the meter.
2. Do not open the meter without allow from professional person.
3. Please keep the manual, it is useful when you use it.
Forbidden
1. Opening the equipment by using tools (screwdrivers,etc.) without
allow.
2. Measuring to sun.
3. Others measuring out of appointed range.
4. Immersing the equipment in water.
5. Cleaning the lens using alcohol or any other organic solvent.
6. Wiping the lens directly with fingers or other rough surfaces.
7. Powering the equipment beyond the rated DC voltage.
